|
|
AVR USB
Programmer - Telwis. Description AVR-USB is designed to work with family AVR ATMEL microcontrolers. Works with very popular software CodeVisionAVR and AvrOspII as AVR-Prog(910). This programmer communicates with PC via USB socket (both protocols 1.0 & 2.0 are supported). No external power supply is needed. There are two ways of programming microcontrolers possible: via 10 pins standard ISP socket just like other programmers do and ... that's a very usefull feature - just placing microcontroler chip into one of nine sockets. As you can see the pictures below, programmer is designed with nine diffrent sockets: DIP8, DIP14, 2 x DIP20, DIP28, DIP40, PLCC44 so there is no need to buy additional adapters. Of course you say well, but where I insert my SMD chips? That's easy too. Just read/write the chip using 10 wires ribbon cable. Most boards are designed for programming on board having that standard 10 pins ISP AVR socket. (the 10 wires ribbon cable is also included in the set ... see picture down below). What microcontroler chips are supported by this programmer? Here is a table of family ATtiny, Atmega and AT90Xxxxx AVR chips supportedi:
List of microcontrolers
* - Read/Write in motherboard only
|
|||||
|
||||||
|
||||||
|
||||||
|
car
diagnostics, car electronics, diagnostic tools, obd cables, programming tools,
diagnostic interfaces, programmers, avr, avr-usb
| ||||||